The stairwell is the most punishing surface in a Nigerian home and the one most often left until last. It takes hands on the wall on every climb, furniture dragged up and down, and light from a window at the top that rakes down the wall and shows every ridge and patch.
It is also the hardest area to paint, because most of it cannot be reached from the floor. That combination is why stairwells often look worse than the rooms below them, sometimes within a year of a full repaint.
Why the stairwell wears first
Four things happen in a stairwell that do not happen in a bedroom:
- Hands. People touch the wall on the way up, usually in the same place, and hand grease is what dissolves a cheap film
- Loads. Bags, boxes and furniture are carried past the same corner, and the wall takes the scrape
- Raking light. Light from a landing window comes across the wall at a shallow angle, which exaggerates every imperfection in the plaster and every brush mark in the paint
- Airflow. Stairwells are tall and narrow, so they are harder to ventilate and paint dries unevenly in them
The result is that a stairwell finished to the same standard as a bedroom looks worse, not because the work was worse but because it is judged under harsher light and heavier use.
Access comes first
Decide how you will reach the top before you buy paint. Options, in order of preference for a full-height stairwell:
- A scaffold tower or a proper platform, which is the safe way to reach a ceiling two storeys up
- A ladder set on the floor, for the lower half, with someone footing it
- An extension pole for cutting in along the top edge, which avoids leaning out
What not to do: stand a ladder on a stair tread. The feet sit on an incline, the ladder is not designed for it, and it is the most common way people fall while decorating. If you cannot reach a section safely, that section waits for equipment rather than being attempted from a chair.
The order of work
Stairwells are painted from the top down, and the awkward parts come before the easy ones:
- Clear the stairs and protect the treads with dust sheets taped down
- Dust and wash the walls, paying attention to the hand-height band on both sides
- Fill and sand, then dust off. Do this before any paint is opened
- Paint the ceiling and the high wall first, while the equipment is in place
- Work down the stairwell walls, then finish with the lower wall and the skirting
- Paint the balustrade and handrail last, so they are not touched while wet
Doing the high work first means you are not standing under wet paint later, and it means the equipment is hired or borrowed once.
Choosing the finish
Split the wall. A washable finish on the lower half and around the hand-height band, where grease and scuffs land, and a matt or standard emulsion above, where nothing touches the wall and the light is less critical.
Prestige Satin Finish is the right choice for the lower section and for any wall within reach of a hand. It can be wiped, which matters because a stairwell is the one place in the house where cleaning beats repainting.
For the balustrade, handrail and spindles, Prestige Premium Plus Gloss gives the hard film those surfaces need. Spindles take knocks from bags and vacuum cleaners, and the handrail is gripped every day.
Avoid a full gloss on the walls themselves. It shows every imperfection in raking light, which is exactly the condition a stairwell creates.
The balustrade is a separate job
Wood and metal balustrades need different preparation, and both need more care than the walls.
Wood should be sanded to a key, with any loose or split sections repaired first. Gaps between spindles and the handrail should be filled before painting, not after. Knots on bare pine need sealing or they will bleed through.
Metal needs rust taken back and a primer before gloss, as with any exterior metalwork. Painted hinges and brackets bind, so mask them.
Spindles are slow work. A brush rather than a roller, one spindle at a time, working from the top of each one downward so runs finish at the base rather than across the handrail.
Cutting in around stairs
The junction between the wall and the stringer, and the line where the skirting meets a stair string, is where a stairwell looks either finished or amateur. Take it slowly with a brush and a steady hand rather than relying on tape. Tape on fresh paint lifts a strip of the film when it comes off, and on an angled stringer the line is never as straight as it looked.
Keep a damp cloth with you for the treads. Paint on a stair tread is a slip hazard while wet and a permanent mark once dry.
Planning it into a bigger job
If the house is being repainted room by room, do the stairwell before the flooring goes down, or protect the treads properly if the floor is already finished. It is the one area where paint on the floor is genuinely difficult to remove, because the treads are walked on before the paint has cured.
It is also worth doing at the same time as the doors and skirting on that level, since the same preparation and the same trim product are involved, and the disruption of clearing the stairs happens once rather than twice.
Getting the stairwell right
Tell us the height of the stairwell, whether the balustrade is timber or metal, and how much of the wall is within reach, and we will tell you what to buy and how to sequence it. Call +234 802 562 5333 or message us on WhatsApp.