Ceilings are the surface people notice last and judge first. Light from a window or a bulb rakes across a ceiling at a shallow angle, which exaggerates every patch, every roller mark and every thin coat. A wall can hide a poor job. A ceiling cannot.
The mistake is treating the ceiling as the leftover part of the work, painted with whatever wall emulsion is left in the tin. It is a different surface, and in most Nigerian homes it is two different surfaces in the same room.
POP and plaster behave differently
Plaster of Paris is gypsum. It is porous, it absorbs unevenly, and a wall emulsion applied straight onto new POP dries patchy — lighter and darker areas that a second coat does not fully even out. New POP needs sealing before it is painted.
Plaster and concrete ceilings behave more like walls, but they still catch light at the worst possible angle, so even coverage matters more than the exact colour.
Fibreboard and timber ceilings are a third case again. They move with humidity, the joints open, and they need a primer suited to timber before anything else.
The right products
- Prestige Best for POP — designed for POP ceilings, cornices and ceiling roses. This is the product for the decorative ceiling detail that runs through most modern Nigerian homes.
- Prestige Matt Finish — for plastered ceilings, where a flat finish hides imperfections best.
- Prestige Premium Plus Gloss — for timber trim, exposed beams and batten detail.
Why matt, and why never thinned
Matt hides. A satin or gloss ceiling reflects the light source back at you and shows every ripple in the plaster, which is the opposite of what a ceiling needs.
Thinning paint to make it go further is the other common error. A thinned coat covers less area, not more, because the pigment is spread too thin to hide what is underneath. It also dries with visible bands where the roller overlapped. If the tin says a coverage figure, that figure assumes the paint is used as supplied.
Preparation
- Dust the ceiling. Cobwebs and settled dust hold the paint off the surface. A dry brush or a vacuum with a brush attachment.
- Fill cracks with Prestige Super Filler and sand flush. Ceiling cracks are usually movement, not structure, but a crack that keeps reopening needs looking at.
- Seal new POP before painting. This is the step that prevents the patchy first coat.
- Seal stains. A water stain will bleed through a fresh coat unless it is sealed first. Paint alone does not block it.
- Two coats with a roller on an extension pole, working in strips and keeping a wet edge.
Water stains are a leak, not a paint problem
A brown ring on a ceiling is water. Somewhere above it there is a leaking roof, a failed flashing, a pipe, or a bathroom. Painting over the stain without finding the leak guarantees it comes back, and the new coat will blister as the water pushes through.
Find the leak, fix it, let the ceiling dry properly, then seal the stain and paint. In a bungalow this is usually a roof issue. In a two-storey house, check the bathroom above first.
How much paint a ceiling needs
Ceiling area is simply the floor area of the room, so it is easier to calculate than walls:
- A 5m by 4m living room has a 20 square metre ceiling
- A three-bedroom flat totals roughly 69 square metres of ceiling across all rooms
- At two coats and around 11 square metres per litre per coat, 69 square metres needs about 13 litres
- Add 10 per cent, and budget 14 litres — three or four 4 litre tins
POP detail — coves, roses, stepped ceilings — adds surface area that is hard to measure. Allow an extra tin on a heavily detailed ceiling. Confirm the coverage on the product you buy.
Common mistakes
- Using leftover wall emulsion, thinned, on a ceiling
- Skipping the sealer on new POP and then wondering why the first coat is patchy
- Painting over a water stain without fixing the leak
- Cutting in badly at the wall line, which is the first thing anyone sees
- One heavy coat instead of two even ones
Getting a ceiling priced
Why ceilings crack
A cracked ceiling is usually not a paint problem, and repainting over a moving crack simply makes it visible again within months.
Ceilings crack for four reasons. Movement in the structure above, which is normal in a building that has settled and shows as a crack along a joint or across a corner. Plaster or POP drying and shrinking, common in a new building in its first year. Water from a roof or a bathroom above, which starts as a stain and becomes a crack as the plaster softens. Poor joint preparation, where the tape or mesh was not bedded properly, which is the one that is genuinely a workmanship fault.
What to do depends on which one you have. A hairline crack that appeared once and stopped moving should be filled, sanded flush and painted. A crack that keeps reopening needs a flexible filler and a wider repair, and one that is spreading or accompanied by a stain needs the cause found before any paint goes near it.
Water stains need a stain-blocking primer or they will bleed through the new coat, however many times you paint over them. That is the single most common ceiling repaint that fails.
For the paint itself, the guidance above holds: matt on plaster or POP, a mould-resistant matt in wet rooms, and never a sheen on a ceiling you want to look flat.
Ceilings are quoted by area and by height. Tell us the room sizes, the ceiling type and whether there is POP detail. Call +234 802 562 5333, message WhatsApp, or send your project details.